Cessna 182 Turbo '22

Products installed/used: AVI64C Smart Oxygen system, modified by adding back-up at pilot and co-pilot.

Installation time: 15 hours over 2 days.

This pretty bird has a very clean and elegant installation of the 4-place system with the customer preferred addition of back-up lines at both pilot and co-pilot.

The tailcone was chosen as the location for the AVI64C control box installation location.

AVI64C control box is mounted and the access channel is available to route tubing and wires into cabin.

AVI tubing bulkhead and Meso tank sensor bulkhead installed on side panel of the baggage compartment. Heath sheething included and recommended on the pressurized portion of the line between the bottle and AVI control box.

Bottle clamps mounted to baggage compartment flooring. Bulkheads installed in baggage panel are labeled and connected to AVI control box in tailcone. 

Bottle mounted. Tubing connected from bulkhead with heat sheething to the regulator, labeled "main ox". Tubing connect from the bulkhead to the back-up portion of the regulator, labeled "aux ox". Meso tank pressure line connect to bottle transducer. 

Clean and elegant installation.

AVI control button and placard wired and mounted to avionics panel.

Pilot cannula bulkhead port, back-up port, and placards mounted and connected. 

Co-pilot cannula bulkhead port, back-up port, and placards mounted and connected. 

Rear seat bulkhead port and placard mounted and connected.   

Other rear seat bulkhead port and placard mounted and connected.  

Ready for a test flight!